ASTM A203 Grade F Steel Plate for Cryogenic Se

The demand for reliable materials in cryogenic service applications has increased significantly with the rapid growth of LNG terminals, industrial gas storage facilities, and low-temperature pressure vessels.

2026-06-24
Benefits of Using ASTM A203 Grade F Steel in L

As the global demand for liquefied natural gas (LNG) continues to grow, the need for reliable materials for cryogenic storage systems has become increasingly important.

2026-06-18
ASTM A203 Grade E: Low-Temperature Nickel-Allo

For engineers specifying materials for cryogenic pressure vessels, finding the balance between strength and ductility at sub-zero temperatures is challenging.

2026-06-12
Low-Temperature Toughness and Applications of

In industries where equipment must operate reliably under freezing or cryogenic conditions, material selection becomes a matter of safety and structural integrity.

2026-06-01
ASTM A203 Grade B vs ASTM A106 Grade B

While both ASTM A203 Grade B and ASTM A106 Grade B serve critical roles in industrial applications, they are fundamentally different in composition, purpose, and performance.

2026-06-01

Need advice, or a quote?

EN 10028-3 P 275 NL1 steel, EN 10028-3 P 275 NL1 steel hardness and heat treatment specification

EN 10028-3 P 275 NL1 steel is one kind of boiler and pressure vessel steel. EN 10028-3 P 275 NL1 steel is widely used in petroleum, chemical engineering, power plants, boilers and other industries for the production of the reactor, heat exchangers, separators, tank, gas tank, nuclear reactor pressure vessel, boiler, liquefied petroleum gas cylinders, Hydropower high-pressure pipes, turbine spiral case equipment and components.

EN 10028-3 P 275 NL1 steel hardness and heat treatment specification:

Annealing hardness HBS	Cold pull hardness HBS	Preheating temperature ℃	Quenching temperature ℃		Holding time min	Hardening medium	Temper temperature ℃	After tempering hardness ≥HRC
			salt-bath furnace	controlled atmosphere furnace
235	262	788	1191	1204	5～15	air cooling	522	60

Steel plate/Sheet thickness / mm	σb MPa	σs ≥/MPa	δ Samples from the standard for 50 mm (2 in)	180 ° of cold bending test
				longitudinal	horizontal
Hot-rolled/Cold rolling:5 - 150	520	415	16～18	2a	3.5a
Note: (1) listed in the table apex diameter (d), to steel thickness (a) multiples said. (2) in the ASTM A6 standard specified scope can meet any additional conditions. (3) from the standard for 50 mm (2 in). Mechanical properties Mechanische Eigenschaften Caracteristiques mecaniques ReH Minimum yield strength / Mindestwert der oberen Streckgrenze / Limite d’elasticite minimale Rm Tensile strength / Zugfestigkeit / Resistance a la traction A Minimum elongation / Mindestwert der Bruchdehnung / Allongement minimal J Notch impact test / Kerbschlagbiegeversuch / Essai de flexion par choc

BEBON STEEL can offer a lot of EN 10028-3 P 275 NL1 steel, otherwise, including its chemical composition and mechanical property. If you are interested in EN 10028-3 P 275 NL1 steel, please contact BEBON STEEL.